Home - Knowledge - Details

Analog 8-wire resistive technology


Analog 8-wire resistive technology was developed as an advanced version of 4-wire resistive technology, but the technology is silmilar to 4-wire.


8-wire resistive touch screen structure8 wire


8-wire resistive touch screen structure is just the same as the analog 4-wire resistive touch technology with two transparent conductive sheets facing each other. One sheet has electrodes on right and left sides, and the other sheet has electrodes on top and bottom sides. Voltage is imposed on the sheet with electrodes on right and left sides, then a touched point in X direction is detected as the voltage is measured by the other sheet. Then, voltage is imposed on the sheet with electrodes on top and bottom sides, then a touched point in Y direction is detected as the voltage is measured by the other sheet.

 


The difference is there are additional wirings connected to each electrode in analog 8-wire resistive technology. Each electrode is added with one more wiring. These added wirings work as supplemental electrodes and measure voltage on each electrodes, then feedback the information to the controller.And the addition of four more sense wires, two on each layer. These additional sensing points are essentially used to stabilize the system and reduce the drift caused by environmental changes. 


Resistive technology requires a task called "calibration" before using it. It is the task to match the touched points on touch screen with positional data of cursor on the display. Calibration is the task to align a touch screen's coordinate to the display behind it. Analog 4-wire resistive technology required calibration not only at the beginning but regularly because touch detecting points are gradually going off the alignment due to change of resistance value on wiring and/or connector parts with the passage of time. In analog 8-wire resistive technology, supplemental electrodes measure the voltage on each electrode automatically, and feedback the measured values to the controller. The voltage detected at touching is transformed into locational information in the relative ratio with the feedback voltage. In this way, the effects of voltage change at electrodes can be cancelled, thus recalibration would not be required. So, analog 8-wire resistive technology is better than analog 4-wire resistive technology because it corrects the alignment automatically and saves the trouble of recalibration.


Make camparison between 4-wire technology and 8-wire technology


As in 4-wire technology, the major drawback is that one coordinate axis uses the outer, flexible coversheet as a uniform voltage gradient, while the inner or bottom layer acts as the voltage probe. The constant flexing that occurs on the outer coversheet alters its resistance with usage, thereby degrading the linearity and accuracy of this axis.



The demand for 8-wire resistive touch panel is going down after 1990s. This is because design and materials of resistive touch screens have been improved, and the recent 4-wire resistive touch screens can be used for long enough without recalibration in many applications. Although the added four sensing points helps stabilize the system against drift, they do not improve the durability or life expectancy of the screen. So 8-wire systems are usually seen in sizes of 10.4 inches or larger, where the drift can be significant.


Technologies of Touch Screen

Resistive Technology : Analog 4-wire Resistive, Analog 5-Wire Resistive, Analog 7-wire Resistive, Analog 8-wire Resistive, Features of resistive technology


Capacitive Technology: Surface Capacitive touch technology, Projected Capacitive touch technology



Send Inquiry

You Might Also Like